
Add to Cart
The disposable vacuum blood collection container consists of a test tube, a plug, a cap, a label, additives (if any) and additives (if any).
Sodium citrate 9:1, Sodium citrate 4:1, Heparin sodium, Liheparin opening, Liheparin Lin/separation glue coagulation/separation glue, curing accelerator, EDTAK2 heparin sodium/sodium fluoride, EDTAK2 / separation adhesive, EDTAK3 EDTAK3 / separation adhesive, Heparin sodium/separation adhesive, no addition
Used in conjunction with disposable intravenous needles for the collection, transportation and preservation of human venous blood.
The appropriate vascular type was selected according to the purpose of routine laboratory tests | ||
Types of additives | Additive code | Recommended colors |
No additives | Z | red |
Accelerator | None | Red/orange |
Separation gel / accelerator | None | yellow |
Heparin lithium | LH | green |
Heparin sodium | NH | green |
Heparin lithium / separation gel | None | green |
Edtak3 / separator | None | violet |
Heparin sodium / separation gel | None | green |
EDTAK2 / separator | None | violet |
Sodium citrate 9:1 | 9NC | wathet |
Sodium fluoride / heparin sodium | FH | grey |
EDTAK2 | K2E | violet |
EDTAK3 | K3E | violet |
Sodium citrate 4:1 | 4NC | black |
1. Select the venipuncture site below the reaper's arm, affix the blood collection tape, and then disinfect.
2. Loosen the sheath of the blood collection needle, put the blood cap of the blood collection vessel up, arm down, and enter the vein.
3. The other end penetrates the diaphragm of the rubber plug to prevent side penetration and early loss of floating pressure.
4. After the blood enters the blood collection container, the blood collection belt should be untied immediately. After blood collection, the needle was pulled out from the vein, and the puncture site was compressed with disinfectant to stop the bleeding.
5. After blood collection, turn over the sampler and shake it evenly 5 times. Observation site.
6. After use, please put the disposable vacuum blood collection container into the special recovery machine.
Store in a dry, well-ventilated and clean room with no corrosive gas and relative humidity above 80%
1. This product is disposable.
2. Do not use when the tube body is damaged or the plug is loose.
3. After blood collection, the vacuum sampling vessel with anticoagulant should be mixed 5-8 times in reverse to ensure the complete fusion of anticoagulant and blood sample.
4. After blood collection, erect the vacuum sampling container with coagulant or separation glue. Wait until the blood is completely coagulated, then centrifuge the serum.
5. Special vacuum sampling vessels are used at high altitudes.
6. Products should only be used by trained medical personnel in accordance with the relevant operating procedures of the medical department.